Mapping where groundwater in sub-Saharan Africa is acidic or corrosive enough to quickly rust the galvanised-iron pipes and rods of village hand pumps, so that new and repaired pumps in those places use stainless steel or plastic parts
- Good it would do
- 2 / 5
- Can AI help
- 2 / 5
- How neglected
- 4 / 5
- Can we check it
- 4 / 5
Why it's on hold
Parked: no groundwater corrosivity map exists and the World Bank's model regulation asks for one, but open pH data cover about four countries, even measured pH below 6.5 only raises galvanised-pipe corrosion from 30% to 61%, and no ministry or buyer has asked for a map rather than a blanket ban.
Why it's stuck
The problem is known to engineers but has no map. A July 2023 report on Zambia says rapid corrosion has been found "in at least 22 countries in sub-Saharan Africa".
What we'd try
Gather groundwater chemistry measurements (pH, dissolved oxygen, chloride and others) from national surveys and published studies across sub-Saharan Africa. Then train machine-learning models on geology, climate, soil and terrain maps to predict how likely groundwater is to be corrosive at any place.
We'd look again if
All three: (1) a ministry (Zambia, Uganda, Malawi), a regulator using the World Bank model regulation, or Stop the Rot faces a named decision (scope of a galvanised-iron ban, where to lift Uganda's suspension, which pumps to replace first); (2) georeferenced pH and independent pipe-condition data for that country become available to the lab; (3) a life-cycle cost comparison shows when geographic targeting could beat a blanket rule or site testing.
Think we got it wrong?
Ruled-out problems can come back. Tell us what we missed.
Members can read the full record for this problem, check its sources and comment. Open the member view →